Issue

Vol. 34 No. 12 (2022): Vol 34 Issue 12, 2022

Copyright (c) 2022 AJC

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Phase and Electrical Properties of Rice Husk Silica-based Na2FeSiO4 Precursors Sintered at High Temperature

https://doi.org/10.14233/ajchem.2022.23958
Agus Riyanto
Department of Physics, Universitas Lampung, Bandar Lampung, Indonesia
Rezeki Sofi Karimah
Department of Physics, Universitas Lampung, Bandar Lampung, Indonesia
Erasri Yuni Suhesti
Department of Physics, Universitas Lampung, Bandar Lampung, Indonesia
Novita Sari
Department of Physics, Universitas Lampung, Bandar Lampung, Indonesia
Sri Wahyu Suciyati
Department of Physics, Universitas Lampung, Bandar Lampung, Indonesia

Corresponding Author(s) : Agus Riyanto

agus.riyanto@fmipa.unila.ac.id

Asian Journal of Chemistry, Vol. 34 No. 12 (2022): Vol 34 Issue 12, 2022

Abstract

The aim of this work is to characterize the phase and electrical properties of Na2FeSiO4 precursor synthesized by the sol-gel technique and then sintering with a holding period of 10 h. The FTIR analysis indicates the presence of Na-O, Fe-O, Si-O and Si-O-Si groups. Their phases were analyzed using XRD coupled with qualitative and quantitative analysis. Meanwhile, the electrical properties were characterized using UV-Vis DRS and LCR meter. The phase analysis revealed that the samples were dominated by SiO2 and Na2FeSiO4 and were followed by Fe2O3, Fe2SiO4 and Na2SiO3. There was no substantial differences in phase composition over the sintering temperature range of 805-815 ºC. However, the volume of cell units in each phase increased gradually with an increase in sintering temperature and was followed by the increasing electrical conductivity of the samples.

Keywords

Electrical properties Na2FeSiO4 Phase Rice husk silica Sintering
Riyanto, A., Sofi Karimah, R., Yuni Suhesti, E., Sari, N., & Wahyu Suciyati, S. (2022). Phase and Electrical Properties of Rice Husk Silica-based Na2FeSiO4 Precursors Sintered at High Temperature. Asian Journal of Chemistry, 34(12), 3327–3332. https://doi.org/10.14233/ajchem.2022.23958
Download Citation
Endnote/Zotero/Mendeley (RIS)
BibTeX
References
  1. C. Eames, A.R. Armstrong, P.G. Bruce and M.S. Islam, Chem. Lett., 24, 2155 (2012); https://doi.org/10.1021/cm300749w
  2. P. Vajeeston and H. Fjellvag, RSC Adv., 7, 16843 (2017); https://doi.org/10.1039/C6RA26555C
  3. P. Sivaraj, K.P. Abhilash, B. Nalini, P. Balraju, S.K. Yadav, S. Jayapandi and P. Christopher Selvin, Ionics, 25, 2041 (2019); https://doi.org/10.1007/s11581-018-2685-1
  4. Z. Ye, X. Zhao, S. Li, S. Wu, P. Wu, M.C. Nguyen, J. Guo, J. Mi, Z. Gong, Z.-Z. Zhu, Y. Yang, C.-Z. Wang and K.-M. Ho, Electrochim. Acta, 212, 934 (2016); https://doi.org/10.1016/j.electacta.2016.07.073
  5. S. Guo, J. Li, Q. Xu, Z. Ma and H. Xue, J. Power Sources, 361, 285 (2017); https://doi.org/10.1016/j.jpowsour.2017.07.002
  6. S. Li, J. Guo, Z. Ye, X. Zhao, S. Wu, J.-X. Mi, C.-Z. Wang, Z. Gong, M.J. McDonald, Z. Zhu, K.-M. Ho and Y. Yang, ACS Appl. Mater. Interfaces, 8, 17233 (2016); https://doi.org/10.1021/acsami.6b03969
  7. Y. Kee, N. Dimov, A. Staykov and S. Okada, Mater. Chem. Phys., 171, 45 (2016); https://doi.org/10.1016/j.matchemphys.2016.01.033
  8. K. Kaliyappan and Z. Chen, Electrochim. Acta, 283, 1384 (2018); https://doi.org/10.1016/j.electacta.2018.07.034
  9. Z. Feng, M. Tang and Z. Yan, Ceram. Int., 44, 22019 (2018); https://doi.org/10.1016/j.ceramint.2018.08.186
  10. W. Guan, B. Pan, P. Zhou, J. Mi, D. Zhang, J. Xu and Y. Jiang, ACS Appl. Mater. Interfaces, 9, 22369 (2017); https://doi.org/10.1021/acsami.7b02385
  11. Y.E. Simsek, Acta Phys. Polineca A, 132(3-II), 1002 (2017); https://doi.org/10.12693/APhysPolA.132.1002
  12. R.A. Bakar, R. Yahya and S.N. Gan, Procedia Chem., 19, 189 (2016); https://doi.org/10.1016/j.proche.2016.03.092
  13. N.N. Ngoc, L.X. Thanh, L.T. Vinh and B.T. Van Anh, Vietnam J. Chem., 56, 730 (2018); https://doi.org/10.1002/vjch.201800079
  14. A. Riyanto, S. Sembiring, A.R. Amalia, A. Astika and R. Marjunus, J. Phys. Conf. Ser., 1572, 012003 (2020); https://doi.org/10.1088/1742-6596/1572/1/012003
  15. S. Sembiring, W. Simanjuntak, R. Situmeang, A. Riyanto and P. KaroKaro, J. Asian Ceram. Soc., 5, 186 (2017); https://doi.org/10.1016/j.jascer.2017.04.005
  16. S. Sembiring, W. Simanjuntak, R. Situmeang and A. Riyanto, J. Ceram. Silik., 62, 163 (2018); https://doi.org/10.13168/cs.2018.0008
  17. S. Sembiring, A. Riyanto, W. Simanjuntak and R. Situmeang, Orient. J. Chem., 33, 1828 (2017); https://doi.org/10.13005/ojc/330427
  18. S. Sembiring, A. Riyanto, R. Situmeang and Z. Sembiring, J. Ceram. Silik., 63, 277 (2019); https://doi.org/10.13168/cs.2019.0021
  19. A. Altomare, C. Cuocci, C. Giacovazzo, A. Moliterni and R. Rizzi, J. Appl. Cryst., 41, 815 (2008); https://doi.org/10.1107/S0021889808016956
  20. V.S. Rangasamy, S. Thayumanasundaram and J. Locquet, Electrochim. Acta, 276, 102 (2018); https://doi.org/10.1016/j.electacta.2018.04.166
  21. R. Jain, V. Luthra, M. Arora and S. Gokhale, J. Supercond. Nov. Magn., 32, 325 (2019); https://doi.org/10.1007/s10948-018-4717-5
  22. K.S. Hui and C.Y.H. Chao, J. Hazard. Mater., 137, 1135 (2006); https://doi.org/10.1016/j.jhazmat.2006.03.050.
  23. M. Sheykhan, A. Yahyazadeh and L. Ramezani, Mol. Catal., 435, 166 (2017); https://doi.org/10.1016/j.mcat.2017.03.032
  24. U. Kalapathy, Bioresour. Technol., 73, 257 (2000); https://doi.org/10.1016/S0960-8524(99)00127-3
  25. U.O. Aroke, A. Abdulkarim and R.O. Ogubunka, ABTU J. Environ. Technol., 6, 42 (2013).
  26. A. Célino, O. Gonçalves, F. Jacquemin and S. Fréour, Cabohydr. Polym., 101, 163 (2014); https://doi.org/10.1016/j.carbpol.2013.09.023
  27. C. Ma, C. Yin, Y. Fan, X. Yang and X. Zhou, J. Mater. Sci., 54, 9372 (2019); https://doi.org/10.1007/s10853-019-03585-7
  28. J. Zhuang, M. Li, Y. Pu, A.J. Ragauskas and C.G. Yoo, Appl. Sci., 10, 4345 (2020); https://doi.org/10.3390/app10124345
  29. A.B.D. Nandiyanto, R. Oktiani and R. Ragadhita, Indones. J. Sci. Technol., 4, 97 (2019); https://doi.org/10.17509/ijost.v4i1.15806
  30. M.H.S. Abadi, A. Delbari, Z. Fakoor and J. Baedi, J. Ceram. Sci. Technol., 46, 41 (2015); https://doi.org/10.4416/JCST2014-00028
  31. P. Sivaraj, B. Nalini, K.P. Abhilash, D. Lakshmi, P.C. Selvin and P. Balraju, J. Alloys Compd., 740, 1116 (2018); https://doi.org/10.1016/j.jallcom.2018.01.051
  32. B. Ali, A. Ur-Rehman, F. Ghafoor, M.I. Shahzad, S.K. Shah and S.M. Abbas, J. Power Sources, 396, 467 (2018); https://doi.org/10.1016/j.jpowsour.2018.06.049
  33. E.H. Kisi, Mater Forum, 18, 135 (1994).
  34. S. Sembiring, W. Simanjuntak, R. Situmeang, A. Riyanto and K. Sebayang, Ceram. Int., 42, 8431 (2016); https://doi.org/10.1016/j.ceramint.2016.02.062
  35. R. Dalven, Phys. Rev. B, 8, 6033 (1973); https://doi.org/10.1103/PhysRevB.8.6033
  36. T.D. Malevu and R.O. Ocaya, Int. J. Electrochem. Sci., 10, 1752 (2015)
Read More
Author biographies is not available.
Download
PDF
Statistic
Read Counter : 0 Download : 0