Department of Nuclear and Quantum Engineering, Korea Advanced Institute of Science and Technology, 373-1 Guseong-dong, Yuseong-gu, Daejeon 305-701, Republic of Korea ; Nuclear Chemistry Research Division, Korea Atomic Energy Research Institute, 989-111 Daedeok-daero, Yuseong-gu, Daejeon, 305-353, Republic of Korea
Kevin James Daub
Department of Chemistry, Western University, 1151 Richmond street, London, Ontario, N6A 3K7, Canada
Sang-Hyuk Jung
Nuclear Chemistry Research Division, Korea Atomic Energy Research Institute, 989-111 Daedeok-daero, Yuseong-gu, Daejeon, 305-353, Republic of Korea
Min Ju Kim
Department of Nuclear and Quantum Engineering, Korea Advanced Institute of Science and Technology, 373-1 Guseong-dong, Yuseong-gu, Daejeon 305-701, Republic of Korea ; Nuclear Chemistry Research Division, Korea Atomic Energy Research Institute, 989-111 Daedeok-daero, Yuseong-gu, Daejeon, 305-353, Republic of Korea
Jei-Won Yeon
Nuclear Chemistry Research Division, Korea Atomic Energy Research Institute, 989-111 Daedeok-daero, Yuseong-gu, Daejeon, 305-353, Republic of Korea
Kyuseok Song
Nuclear Chemistry Research Division, Korea Atomic Energy Research Institute, 989-111 Daedeok-daero, Yuseong-gu, Daejeon, 305-353, Republic of Korea
Corresponding Author(s) : Jei-Won Yeon
yeonysy@kaeri.re.kr
Asian Journal of Chemistry,
Vol. 25 No. 12 (2013): Vol 25 Issue 12
The deposition of B4C microparticles was carried out under boiling water conditions. We investigated the effect of heater power, the presence of Fe or Ca ions and the presence of pre-formed oxide layers on the deposition of B4C microparticles. Starting from a power level inducing bulk boiling, the deposition amount of B4C microparticles increased with an increase of heater power. However, a maximum deposition condition was observed between bulk boiling and film boiling states. The amount of deposited B4C microparticles decreased in the presence of metal ions (Fe or Ca). The metal ions acted as flocculants to decrease the dispersive stability of B4C microparticles rather than a source material for a porous oxide layer to increase the deposition of B4C microparticles. It was observed that B4C microparticles deposited much easier on bare stainless steel surfaces than on surfaces covered with an iron oxide layer under boiling water conditions.
Han, S.-C., James Daub, K., Jung, S.-H., Ju Kim, M., Yeon, J.-W., & Song, K. (2013). Deposition of B4C Microparticles on Boiling Surface in Boric Acid Solution. Asian Journal of Chemistry, 25(12), 7058–7060. https://doi.org/10.14233/ajchem.2013.19